HoMedics THERA-P TI-150 Manual De Instrucciones E Información De Garantía página 10

To review memory readings:
This thermometer automatically stores the last 10 results in
PERSON mode, and the last 10 results in OBJECT mode.
When thermometer is on, press the MEM button.
The most recent temperature you took
in the mode that your thermometer is
in will display along with the memory
mode indicator and the number "1".
Toggle through the memory by
continuing to press and release the
MEM button to review up to ten
memories. Pressing MEM again will
take you back to the most recent
memory.
Figure 10
Memory
Memory Mode
Number
Indicator
17
To review the memory in another mode (person or object),
press MODE while in memory. The 1st memory of the other
mode will appear on the display.
Note: When memory is at capacity, the oldest record will
be deleted to make room for a new reading. Memory will
be cleared as a result of battery removal or power failure.
A default reading of "– –" will be displayed when memory
is cleared until a new temperature reading is taken.
To clear memory:
Press and hold the MEM button for 5 seconds. The thermometer
will beep when the memory is cleared. This clears all memory in
PERSON and OBJECT mode.
18