Taurus BOREAL 12 ELEGANCE Manual De Instrucciones página 9

tightened by turning it in a counter-clockwise direction. Check that the fan blade
rotates freely by turning with your hand.
-Open the securing clip at the bottom of the front guard and loosen the clip
screw. Position the top clip on the uppermost part of the rear guard.
-Push the top clip down and press rim of the front guard onto the rear guard.
Close the bottom clip and tighten the screw.
Assembling the base (Only for the desk fan):
- Put the power cord into the base hole and set the bulge of stand tube align-
ment with space of base hole, and turn the stand tube by clockwise direction.
Assembling the base (Only for the stand fan):
- Insert the lower stand tube (O) into the base hole (L) and keep the bulge (M)
of the stand tube alignment with space of the base hole. Then use four screws
( R) tighten (Fig.1)
- Insert the upper stand tube (N) into the lower stand tube (O), the thread must
be tightened by turning it in a counter-clockwise (Fig 2)
Assembling the grill and the propeller:
-Remove the spinner lock nut and guard lock nut from the motor shaft spindle.
-Fit the rear guard, by positioning on the location pins.
-Secure the guard to the motor body with the guard lock nut (Fig 3)
-Push the fan blade onto the motor shaft by matching the slots on the base of
the blade with the shaft pin.
-Secure the blade with the spinner lock nut. the spinner lock nut must be
tightened by turning it in a counter-clockwise direction. Check that the fan blade
rotates freely by turning with your hand
-Open the securing clip at the bottom of the front guard and loosen the clip
screw.
-Position the top clip on the uppermost part of the rear guard.
-Push the top clip down and press rim of the front guard onto the rear guard.
-Close the bottom clip and tighten the screw.
Instructions for use
Before use:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has been removed.
Use:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
-Turn the appliance on, by using the speed selection buttons.
- Guide the diffuser of the appliance to direct the flow of air in the desired
direction.
- To avoid a fierce start up of the fan, it is advisable to start off from the lowest
speed position and, once the fan has been switched on, progressively increase
the speed to the desired position.
Fan function:
- Select the desired ventilation speed.
0: Fan off
1: Minimal air flow
2: Medium air flow
3: Maximum air flow
Oscillation function:
- The oscillation function makes it possible to direct the flow from the apparatus
so that it automatically alternates over a range of 75º
- To activate this function, press the oscillating knob (H).
- To deactivate this function, pull it up.
Titlting
-The appliance can be adjusted for a desired tilt with your hand.
Once you have finished using the appliance:
-Turn off the appliance by selecting 0 on the speed selector.
-Unplug the appliance to the mains
- Clean the appliance.
Carry handle:
-The device has an handle on the upper part so it can be transported easily
and comfortably.
Cleaning
- Disconnect the appliance from the mains and allow it to cool before underta-
king any cleaning task.
- Clean the equipment with a damp cloth with a few drops of washing-up liquid
and then dry.
- Do not use solvents, or products with an acid or base pH such as bleach, or
abrasive products, for cleaning the appliance.
- Do not let water or any other liquid get into the air vents to avoid damage to
the inner parts of the appliance.
- Never submerge the appliance in water or any other liquid or place it under
running water.
- If the appliance is not in good condition of cleanliness, its surface may
Manual Boreals Elegance.indb 9
degrade and inexorably affect the duration of the appliance's useful life and
could become unsafe to use.
- Then dry all parts before its assembly and storage.
Anomalies and repair
- Take the appliance to an authorised technical support service if product is
damaged or other problems arise. Do not attempt to disassemble or repair the
appliance yourself as this may be dangerous.
For EU product versions and/or in case that it is requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are included
in a collection, classification and recycling system. Should you wish to dispose
of them, use the appropriate public recycling bins for each type of material.
- The product does not contain concentrations of substances that could be
considered harmful to the environment.
- This symbol means that in case you wish to dispose of the
product once its working life has ended, take it to an authorised
waste agent for the selective collection of Waste from Electric and
Electronic Equipment (WEEE).
- The following information details the features related to ecodesign
BOREAL 16C ELEGANCE
Maximum fan flow rate (F)
Fan power input(P)
Service value (SV) (according to IEC 60879)
Standby power consumption (PSB)
Fan sound power level (LWA)
Maximum air velocity( c )
BOREAL 12 ELEGANCE
Maximum fan flow rate (F)
Fan power input(P)
Service value (SV) (according to IEC 60879)
Standby power consumption (PSB)
Fan sound power level (LWA)
Maximum air velocity( c )
This appliance complies with Directive 2006/95/EC on Low Voltage, Directive
2004/108/EC on Electromagnetic Compatibility, Directive 2011/65/EU on the
restrictions of the use of certain hazardous substances in electrical and electro-
nic equipment and Directive 2009/125/EC on the ecodesign requirements for
energy-related products.
69,95 m ³ /min
53,65 W
(m ³ /min)/W
1,3
W
0
dB(A)
63,7
meters/sec
2,99
48,29 m ³ /min
35,13 W
1,37 (m ³ /min)/W
0 W
55 dB(A)
meters/sec
2,74
06/03/15 17:22