Installation Instruction - Friedrich DWC1 Manual De Instalación Y Operaciones

Installation instruction

1. Once mounting location has been located please ensure screws are installed
properly and are tight.
- Install base of controller flush against the wall, ensure that no warping of base otherwise controller operation
may be affected.
2. DWC1 can be installed with the cable in multiple directions.
- Setup directions: Route cable through electrical wall box, top-right or far right-side.
- If setting up DWC1 cable into the top right and far right-side, please do this after removing the plastic
breakaway piece.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
1
2
3
Breakaway locations for cable routing
Installation instruction
2
Owner's & Installation Manual 5
3