Setting And Changing Speed - Waring Commercial WSM10L Manual De Instrucciones

CAUTION

SETTING AND CHANGING SPEED

Three fixed speeds are available for use: first (1), second (2)
and third (3).
IMPORTANT: When mixing product, it is recommended to follow the
Capacity Chart on page 15.
Select the appropriate speed setting by lifting or lowering the speed
control lever.
IMPORTANT: When mixing product, always follow the
recommended agitator and speed setting according to the
Capacity Chart. Refer to Capacity Chart section.
Press the green START button to begin mixing.
CAUTION
Always STOP mixer BEFORE changing speeds. Failure to do so
can damage the gears or other parts and WILL VOID the warranty!
To change the speed while mixing:
a. Press the red STOP button, then wait for the agitator
to come to a complete stop.
b. Change the speed by raising or lowering the speed
control lever.
c. Press the green START button to restart the mixer.
NOTE: Mixer is equipped with motor overload protection. If mixer
shuts off during operation: Press the STOP button, unplug unit from
wall, wait two minutes and plug unit back into the wall. Press the
overload reset button located on the back of mixer.
NOTE: Reduce batch size by 10% if using chilled flour, water below
70˚F, ice, or high-gluten flour.
When the ingredients have been thoroughly mixed, press the red
STOP button to stop the mixer.
Lower bowl by pulling bowl-lift lever forward and down to its
resting position.
Rotate bowl guard to the left, so it is in the open position.
11