Tripp-Lite PDUMVR20NET El Manual Del Propietario página 10

Features
ACCY
CONFIG
A B
13-02-027-933161-revB.indb 10
Mounting Brackets: Use these brackets to mount the PDU.
SNMP Reset Button: Press the reset button with a small tool or paper
clip for 3 seconds to reboot the PDU's network card. Rebooting the
network card will not erase network settings or interrupt AC power.
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity monitoring
and a dry contact interface to control and monitor alarm, security and
telecom devices. Visit www.tripplite.com for ordering information. Note:
Do not connect a keyboard or mouse to this port.
RJ-45 ACCY Port: Reserved for future use.
RJ-45 Configuration Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program. An RJ-45
cable is included with the PDU. If you need a replacement cable, visit
www.tripplite.com for ordering information.
Ethernet Port: Use this RJ-45 jack to connect the PDU to the network
with a standard Ethernet patch cable. The Link LED
indicate several operating conditions, as shown in the table below. This
port is not compatible with PoE (Power Over Ethernet) applications.
Link LED Color
A
Off
Flashing Amber
Flashing Green
Status LED Color
B
Off
Steady or Flashing Green
Steady Amber
10
Network Operating Conditions
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
and Status LED
A B
2/7/2013 1:19:20 PM