Network Connection - Tripp-Lite PDUMVR20NET El Manual Del Propietario

Installation
Network Service Configuration
The following prompts configure the connection methods that the SNMPWEBCARD will accept.
Enable SNTP? [Y]
Enable FTP? [Y]
Port number? [21]
Enable HTTP? [Y]
Port number? [80]
Enable HTTPS? [Y]
Port number? [443]
You can also change the root password, real-time clock and other settings. (Tripp Lite
recommends against changing the default settings unless you are an advanced user with a
specific purpose.) After you have finished entering settings, the PDU will save changes to memory
and reboot (this may take several minutes). After the PDU reboots, the initialization page should
display the new static IP settings.
4-6
Remove Serial Cable: Remove the serial cable from the PDU and proceed to Step

Network Connection

5-1
Connect PDU to Network: While the
PDU is powered, connect a standard
Ethernet patch cable to the RJ-45
Ethernet port on the PDU.
Note: This port is not compatible with PoE
(Power over Ethernet) applications.
5-2
Access PDU with Web Browser: After
an IP address has been assigned to
the PDU, attempt to access it with a
Web browser that supports frames,
forms and Java™. Open a Web browser
on a computer connected to the LAN
and enter the IP address assigned
to the PDU. You should be prompted
for a password
"localadmin" and the default password
is "localadmin". After you enter the user
name and password, the PowerAlert
status page
browser window. For more information
about configuration and operation of the
PDU via the PowerAlert interface, refer
to the SNMPWEBCARD User's Guide,
included on the CD-ROM bundled with
the PDU.
Note for Network Management System
Users Only: Two MIB files - Tripplite.mib
and RFC1628.mib - must be loaded on
each Network Management Station that
will monitor the PDU via SNMP . The files are
provided on the CD-ROM included in the
product package.
13-02-027-933161-revB.indb 7
Enable Telnet Menu? [Y]
Port number? [23]
Enable Telnet Programs? [Y]
Port number? [5214]
Enable SSH Menu? [Y]
Port number? [22]
Enable SSH Programs? [Y]
. The user name is
A
will appear in the
B
Port number? [2112]
Enable SNMP? [Y]
Port number? [161]
Enable SNMPv1? [Y]
Enable SNMPv2c? [Y]
Enable SNMPv3? [Y]
A
B
7
.
5-1
2/7/2013 1:19:15 PM