Eference; System Maintenance; Replacing The Remote Control Batteries; Changing Remote Control Switch Settings - Bose LIFESTYLE VS-2 Guía De Uso

English Español

System maintenance

Figure 25
Installing the remote
control batteries
Français
Changing batteries is the only regular maintenance required.
However, switches inside the remote battery case can be changed, as needed (to select a
new house code, for example). Similar changes may be required for any additional remotes,
purchased for use in other rooms.
Note: For further information on switch settings refer to "Changing remote control switch
settings" below.

Replacing the remote control batteries

Replace all four batteries when the remote control stops operating or its range seems
reduced. Alkaline batteries are recommended.
1. Slide open the battery compartment on the back of the remote (Figure 25).
2. Insert four AAA or IEC-LR3 1.5V batteries, or the equivalent, as shown. Match the +
and – symbols on the batteries with the + and – markings inside the compartment.
3. Slide the battery compartment cover back into place.
AAA batteries (4)
Battery
compartment

Changing remote control switch settings

Each LIFESTYLE ® remote control uses a house code that corresponds to the house code set
in the media center, enabling the two to communicate. If another LIFESTYLE
creates a conflict with your system, you can easily set a new house code in your media center
and its remote control(s) with steps that follow.
Using the remote control:
1. Open the remote control battery cover and locate the miniature switches
(Figure 26 on page 54).
2. Move one or more of switches 1, 2, 3, or 4 in the opposite direction from its current
setting. Use a paper clip, ball point pen, or similar object.
Note: DO NOT change any other switch settings. Moving other switches may disable your
remote control.
3. Replace the battery cover.
+
+
+
+
Battery
compartment
cover
R

EFERENCE

® system nearby
53