Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Hardware Installation
1. Jot down the camera's MAC address for later reference.
2. The camera weighs 3kg. Select a rigid mounting location to prevent vibration to the
camera. Attach the alignment sticker to the wall.
3. Drill 4 pilot holes (9.5mm in diameter and 4cm deep) into the wall, and then hammer
in threaded anchors. Note that you should hammer the anchors with hex nuts on
them so that the threaded poles will not be deformed! If preferred, drill another hole
for routing cables.
SDXXXX
0002D10766AD
4. Remove the hex nuts, washers, and leave one washer on each of the threaded poles.
Ø 9.5mm or 3/8"
EN-3
Publicidad
Tabla de contenido
