Installation Instructions - Climadiff CVP Serie Manual De Utilización

4° INSTALLATION INSTRUCTIONS
Before using your wine cellar
• Remove the inner and outer packaging. Remove your wine cellar from the
transport pallet by unscrewing the two screws on the frame at the back of the
device.
• Before connecting the cellar to the electrical socket, leave it in position for
hours. This will reduce the possibility of malfunction of the refrigeration circuit
due to transport.
• Clean the inside using a soft cloth and lukewarm water.
Using your wine cellar
Your wine cellar must be positioned in a room with an ambient temperature
between 16 and 32°C. Alternatively, if the cellar is fitted with the winter system,
the range is extended to 0 to 32°C
Installing your wine cellar
• This wine cellar is designed for free-standing installation.
• Position it in a place with sufficient strength to support its weight when loaded.
• To get the best from your appliance with the lowest energy consumption, do
not place the appliance close to a heat source (heater, cooker, etc.), do not
expose it to direct sunlight, and do not place it in a room which is too cold.
• Screw the stopper supplied inside the wine cellar to maintain a minimum
distance between the back of the cellar and the wall in front of it is placed.
Ensure that your wine cellar is perfectly horizontal, then slightly raise the two
front feet. (Use of a spirit level is recommended). This will prevent any
movement due to instability, causing noise and vibration, and will ensure that
the door seals perfectly.
24
31