Troubleshooting - Black+Decker JE9000BD Manual De Instrucciones

TROUBLESHOOTING

Overheat protection system: This juicer contains a PTC overheat
protection system. When the appliance is being operated for too long
or with too much load, the PTC protector will shut down the power of
the appliance to protect the unit. If the power shuts down, unplug for 15
minutes and plug back in for normal operation.
Problem
Appliance will
not start when
speed dial is
turned on
The motor of
the appliance
seems to be
struggling
The juice
extractor
has stopped
producing juice
The juice
extractor is not
producing as
much juice as
expected
Appliance stops
running
Cup leaks
or becomes
unscrewed
from base
Juicer does not
activate
Possible cause
The juicer may not be
assembled correctly.
Pulp container may
be full.
Pulp may have
collected under the
cover.
The anti-drip spout
may be closed.
The integrated pulp
container or the
stainless steel filter
may be blocked.
High fiber fruits and
vegetables may be
clogging the stainless
steel filter.
Motor may be
overheating.
Juicing time exceeds
2.5 minutes.
Blade not screwed on
cup tight enough.
Blade is not twisted
into the motor base
Solution
Turn the juicer off and
unplug. Make sure everything
is properly attached and
parts are clean and free of
food remnants.
Turn the appliance off and
empty the pulp container.
Remember, the pulp container
holds about 2L of pulp, do not
allow to get too full.
Turn off and unplug. Remove the
lid and wash thoroughly. Return
lid to appliance.
Check to see if the spout is
closed or open.
Turn appliance off and unplug.
Disassemble the juicer, wash
all parts thoroughly and re-
assemble.
Turn off and unplug the
juicer. Disassemble, wash all
parts and re-assemble.
Unplug appliance and let it cool
for approximately 5 minutes
before continuing use.
Unplug the juicer and remove
the juicer cup.
Re-assemble. Plug in juicer.
Unplug the juicer, turn the blade
base counterclockwise to tighten.
Turn the cup and blade assembly
counterclockwise to remove from
motor base and lift up.
Remove the blade from the
cup and re-install.
Ensure the cup and blade
assembly are properly
twisted into the base.
27