Fulgor Milano CPH 604 G TC Manual De Instrucciones página 25

Error
Problem type
displayed
B Single burner locked
Parasite flame/flame detection
F circuit anomaly on the single
burner
Main valve control circuit
Flt00
anomaly
Anomaly circuit voltage of
Flt01
reference
Flt02 Watchdog circuit anomaly
Flt03 Microcontroller door anomaly
Flt04 Eeprom anomaly
Flt05 Pilot valve circuit anomaly
Limit of 5 unlocks in 15
Flt06
minutes exceeded
Flt08 Power supply circuit anomaly
Generic anomaly
Flt09
Resonator anomaly
Flt0A All burners locked
Communication errors in the
Flt0[
control logic
Error in the control of the
Flt0E
keypad
Possible cause
No gas
Ionization electrode dirty or not hit by the flame
The cook top is not grounded
Ionization electrode wired incorrectly
Failure at the circuit
Failure at the circuit
Failure at the circuit
Failure at the circuit
Failure at the circuit
Failure at the circuit
Failure at the circuit
The burners have been unlocked 5 times in 15
minutes
Failure at the circuit
Power was cut to the device when another type
of failure had occurred previously
Failure at the circuit
No gas
Ionization electrodes dirty or not hit by the flame
The cook top is not grounded
Gas is leaking from one valve that caused the
unwanted lighting of a second burner while the
first was being lit.
This problem is caused by flame in the second
burner for more than 10 seconds.
Failure at the circuit
A mechanical deformation could have
compromised the support of the keypad by the
glass
25
Possible solution
Restore the gas and unlock the
burners
Clean or reposition the
electrode and unlock the
burners
Check the cables and unlock
the burners
Check the wiring
Replace the device
Replace the device
Replace the device
Replace the device
Replace the device
Replace the device
Replace the device
Wait 15 minutes before
unlocking the burners
Replace the device
Unlock the burners
Replace the device
Restore the gas and unlock the
burners
Clean or reposition the
electrodes and unlock the
burners
Check the cables and unlock
the burners
Replace the defective valve
Replace the device
Wait several seconds for the
keypad to recalibrate. If the
error persists, turn the power
off and on. If the error still
persists, replace the device.
GB