Installation - Magic Chef MCSDRY1S Manual De Usuario

INSTALLATION

LOCATION
1. Examine the dryer after unpacking. Check for damage such as a misaligned door, broken
door or dent in the cavity. If any damage is visible, DO NOT install, and notify your dealer
immediately.
2. Check to ensure that you have the wall-mounting kit and four (4) leveling legs.
3. Install the dryer on a flat, level surface. If the surface is uneven, adjust the leveling legs.
If you are going to wall mount your dryer, use the included wall-mounting kit.
4. Install the dryer away from direct sunlight; direct sunlight may affect the acrylic coating,
plastic and electrical components. The room temperature should not fall below 32°F.
5. Check the ventilation. DO NOT block the air vents, especially when the dryer is
installed on a carpeted floor. If the air vents are blocked during operation, the dryer
may overheat and eventually fail. For proper ventilation, allow at least 5 inches of space
between the dryer top, sides, rear, and adjacent surfaces.
6. Install the dryer away from heating appliances and water taps. Keep the dryer away
from heat, steam, or splashing liquids. Never splash water onto the control panel. These
things can adversely affect the wiring and electrical conduction contacts of the dryer.
7. Check the power supply.
a) Check your local power source. The dryer requires a current of
approximately 12 Amperes, 120 Volts, and a 60 Hz grounded outlet.
b) A short power-supply cord is provided to reduce the risks resulting from
becoming entangled in or tripping over a longer cord. Ensure that the dryer does
not stand on its power cord.
c) Use of an extension cord is not recommended. If an extension cord is used:
The marked electrical rating of the cord set or extension cord should be
at the very least equal to the electrical rating of the appliance.
The extension cord must be a grounding type, 3-wire cord.
A longer cord should be arranged so that it will not drape over the
appliance where it can be pulled on by children or tripped over
unintentionally.
d) Plug the dryer into a properly installed receptacle box that is fully grounded.
DO NOT under any circumstances modify, cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an authorized service center.
EN-6