Chapter 1: Product Overview; Bottom Panel; Back Panel - Cisco LinkSys PLE200 Guia Del Usuario

Chapter1
Chapter :
Product Overvew
Thank you for choosing the Linksys PowerLine AV Ethernet
Adapter . It lets you turn the existing powerlines in your
home or office into a high-speed network . This user guide
is intended for use with the PLE200 and PLK200 (Kit of 2
PLE200 Adapters) .
Installation is quick and simple . Connect the Adapter
directly to any Ethernet-enabled device, whether it's a
computer or media center . Once your computers and other
devices are connected to the powerline network, they
can share resources like printers and storage space, and
all kinds of files—music, digital pictures, and documents .
With up to 100Mbps data rates, you can play lag-free,
head-to-head network computer games, and you can run
media-centric applications like streaming video and Voice
over Internet Protocol (VoIP) telephony . And if you use a
PowerLine AV Ethernet Adapter to interface your cable or
DSL router to your powerline network, you'll be able to
connect to the Internet from any computer in the house .
Use the instructions in this user guide to help you install
and use the Adapter . These instructions should be all you
need to get the most out of the Adapter .

Bottom Panel

The Ethernet port is located on the bottom panel of the
Adapter .
ETHERNET The Ethernet port connects to an Ethernet
network cable . The other end of the cable will connect
to your computer or other Ethernet-enabled network
device .
PowerLne AV Ethernet Adapter

Back Panel

The power plug and device password are located on the
back panel of the Adapter .
Power Plug
The power plug (Euro plug shown above)
connects to an electrical outlet in your location .
IMPORTANT: Because the Adapter sends data
over the powerlines of your residence, Linksys
recommends that you plug the Adapter directly
into an electrical outlet . The Adapter has its own
power filter for protection against surges .
Devce Password The Devce Password is located on
the sticker . If you are adding this Adapter to a pre-existing
powerline network with your own Network Password
(not the default), then you may need to enter the Device
Password on the Security tab of the Configuration Utility .
For more information, refer to "Chapter 3: Using the
Configuration Utility . "
Product Overview