Chapter 2: Installation - Cisco LinkSys PLE200 Guia Del Usuario

Chapter2
Chapter :
Installaton
NOTE: If your computer does not have the
Microsoft .NET Framework already installed, the
Setup Wizard will install the software .
1 . Insert insert the Setup Wizard CD-ROM into
the CD drive . The Setup Wizard should run
automatically . If it does not, go to the Start menu
and select Run . In the field that appears, type
D:\setup.exe (if "D" is the letter of your CD drive) and
press Enter .
Insert the CD-ROM
2 . The Language Selection screen will appear . Select the
appropriate language and click Next .
Language Selection Screen
PowerLne AV Ethernet Adapter
3 . On the Welcome screen, click Setup to begin the
installation .
Language Selection Screen
4 . The End User License Agreement screen will appear .
If you agree and want to begin the installation, click
Next .
End User License Agreement Screen
5 . The Preparing to Install screen will appear briefly,
followed by a STOP screen . At this point, connect one
end of an Ethernet network cable to the Ethernet port
of the Adapter . Connect the other end to an Ethernet
port on the computer running the Setup Wizard .
Before plugging in the Adapter, write down the Device
Password printed on the unit .
Installation