en-us
3.
Attaching the appliance to the
installation niche
It is essential to attach the appliance to the top of the
installation niche.
1.
Screw the attachment plate lugs (top) to the
overhead furniture.
2.
If there is a fairly large gap above the appliance, fit
a wooden beam above the appliance, ensuring
that the wooden beam fits the gap exactly.
3.
If there is enough room on the top of the
appliance, fix the attachment plate side lugs (top)
to the side of the niche.
4.
Screw on the bars of the fastening sheets (lateral)
with the cabinet parts located next to them.
Note:
In the case of a Side-by-Side installation this
installation step is not possible. These parts have
been removed.
16
5.
Shorten the fitting strip (a) to fill the gap.
Note:
The appliance will be damaged if the fitting
strip (a) is too long.
6.
Press the fitting strip (a) into the cover strip (b).
7.
Attach the cover strip (b) to the attachment plate
(top).
Note:
In the case of a side-by-side installation connect both
cover rails to the bolt included in the installation
accessories for side-by-side installation.
The following are special installation
steps. Instructions are provided after
chapter C.
Connecting the water, see
■
"Connecting the water to the
appliance".