Features - Tripp-Lite SRCOOLNET Instalación Y Guía De Inicio Rápido

Features

PS/2 Port: Use this port to connect the Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity
monitoring and a dry contact interface to control and monitor
alarm, security and telecom devices. Note: Do not connect a
keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program.
A configuration cable (part number 73-1025) is included with the
SRCOOLNET. If you need to order a replacement cable, visit
www.tripplite.com/support.
Ethernet Port: Use this RJ45 jack to connect the SRCOOLNET to
the network with a standard Ethernet patch cable. The Link LED
and Status LED
C1
in the table below. Does not support PoE (Power Over Ethernet)
C2
applications.
Reset Button: Press the reset button for 3 seconds to reboot the
RESET
SRCOOLNET. Rebooting the SRCOOLNET will not erase network
settings or interrupt AC power. Note: The recessed button is located
just beneath the Ethernet port. Use a pin, paper clip, or pointed
tool to access the button.
13-08-187 93-32CA.indb 12
C2 indicate several operating conditions, as shown
SRCOOLNET Operating Conditions
C1 Link LED Color
Off
Flashing Amber
Flashing Green
C2 Status LED Color
Off
Steady Green
Flashing Amber
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
SRCOOLNET Not Initialized
SRCOOLNET Initialized and Operational
Error - SRCOOLNET Not Initialized
12
C1
9/27/2013 9:25:22 AM