Tripp-Lite SRCOOLNET Instalación Y Guía De Inicio Rápido página 5

Installation
3-3
Connect SRCOOLNET to Computer: Use the included mini-DIN to DB9
configuration cable (part number 73-1025) to connect the SRCOOLNET to the
computer. The circular connector
8-pin mini-DIN serial port (labeled CONFIG)
connector carefully to avoid damaging the pins). The DB9 connector
other end of the cable connects to the computer's serial port
Figure 1
A
Note: Self-adhesive Velcro strips are included for mounting the SRCOOLNET to the
side of the A/C unit. As an alternative, the included rubber feet can be used if the
SRCOOLNET will be freestanding.
3-4
Connect SRCOOLNET to Network: Connect a standard Ethernet patch cable to
the RJ45 Ethernet port on the SRCOOLNET. Note: This port does not support
PoE (Power over Ethernet) applications.
3-5
Connect the SRCOOLNET to the SRCOOL12K or SRXCOOL12K: Using the
dedicated connector
the side of the spot cooler (Refer to Figure 1).
3-6
Connect SRCOOLNET to Power: (Refer to Figure 1). Connect the AC Adapter
B to the SRCOOLNET via the port labeled "DC Power"
end into an AC power source.
Note: The SRCOOLNET must be plugged into a power source protected by a UPS
or Inverter/Charger in order to maintain communications during a power outage.
13-08-187 93-32CA.indb 5
D at one end of the cable attaches to the
B
C
A , connect the SRCOOLNET to the communication port on
E on the SRCOOLNET (Align the
D
E
C
5
F at the
G .
F
G
and plug the other
9/27/2013 9:25:20 AM