Fcc Compliance Statement - Johnson Controls tyco WS4933 Instrucciones De Instalación Y Funcionamiento

FCC Compliance Statement

CAUTION: Changes or modifications not expressly approved by DSC could void your authority to use this equip-
ment.
This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accord-
ance with the manufacturer's instructions, may cause interference to radio and television reception. It has been
type tested and found to comply with the limits for Class B device in accordance with the specifications in Subpart
"B" of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in
any residential installation. However, there is no guarantee that interference will not occur in a particular install-
ation. If this equipment does cause interference to television or radio reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Re-orient the receiving antenna
• Relocate the alarm control with respect to the receiver
• Move the alarm control away from the receiver
• Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional sug-
gestions. The user may find the following booklet prepared by the FCC helpful: "How to Identify and Resolve
Radio/Television Interference Problems". This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402, Stock # 004-000-00345-4.
FCC ID: F5309WS4933
Innovation, Science and Economic Development Canada Statement:
IC: 160A- WS4933A
The letters "IC:" indicate that this is an Innovation, Science and Economic Development Canada's certification
number.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
© 2019 Johnson Controls. All rights reserved. Johnson Controls, Tyco and Product Brand Names (e.g. DSC) are trademarks and/or registered trademarks. Unauthorized use is
strictly prohibited. Tech Support: 1-800-387-3630 (Canada, U.S.)