Compliance With Standards - Johnson Controls PG9200AX Manual Del Usuario

Compliance with standards

USA: FCC- CFR 47 Part 15
UL Resi/Com Burg: UL639
IC RSS – 247
Canada:
ULC Resi/Com Burg ULC-S306
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.Le present
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisee aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le
fonctionnement.
To comply with FCC Section 1.1310 for human exposure to radio frequency electromagnetic fields and IC
requirements, implement the following instruction:A distance of at least 20cm. between the equipment and all persons
should be maintained during the operation of the equipment.Le dispositif doit être placé à une distance d'au moins 20
cm à partir de toutes les personnes au cours de son fonctionnement normal. Les antennes utilisées pour ce produit ne
doivent pas être situés ou exploités conjointement avec une autre antenne ou transmetteur.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
- This Class B digital apparatus complies with Canadian ICES-003.
- Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
UL/ULC Notes
Only model PG9200AX operating in the frequency band 912-919MHz is UL/ULC listed. The PG9200AX has been
listed by UL for commercial and residential burglary applications and by ULC for residential burglary applications
in accordance with the requirements in the Standards UL 639 and ULC-S306 for Intrusion Detection Units.
For UL/ULC installations use these devices only in conjunction with compatible DSC wireless receivers:
HSM2HOST9, HS2LCDRF(P)9, HS2ICNRF(P) 9, PG9920, PowerSeries NEO (v1.37 and higher), PowerSeries Pro
(v1.31 and higher), IQPanel2 (v2.6 and higher), IQHub (v3.0 and higher), IQPanel4 (v4.0 and higher). After installation
verify the product functionality in conjunction with the compatible receiver used.
FCC COMPLIANCE STATEMENT
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio and television reception. However, there is
no guarantee that interference will not occur in a particular installation. If this device does cause such interference,
which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or
more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
FCC ID: F5318PG9200AX
Innovation Science and Economic Development Canada (ISED) Statement
This equipment complies with FCC and ISED Canada RF radiation exposure limits set forth for an uncontrolled
environment.