Clearing Blockages - Hoover S1420050 Manual Del Propietário

Clearing blockages

Remove larger items from carpet and
other surfaces before vacuuming to help
prevent blockages in hose, wands or noz-
zle connector, and to maintain cleaning
effectiveness of your cleaner.
Problem: Cleaner won't run
Possible cause
Possible solution
• Not firmly plugged in.
• Plug in firmly
• No voltage in wall plug.
• Check fuse or breaker.
• Blown fuse/tripped breaker.
• Replace fuse/reset breaker.
Problem: Suction low
Possible cause
Possible solution
• Bag full
• Replace paper filter bag.
• Blockage in nozzle or hose
• Remove blockage (see "Clearing
blockages" section)
• Secondary filter dirty.
• Clean filter.
Problem: Nozzle won't pick up
Possible cause
Possible solution
• Nozzle brush worn.
• Replace brush.
8
To check for blockages, proceed with each
of the following steps until the blockage
is found.
1. Turn cleaner OFF and disconnect
wands from hand grip.
2. Turn cleaner ON and check hose
end for suction. Turn cleaner OFF and
remove any blockages.
3. Remove nozzle from wands and attach
wands to hose. Turn cleaner ON and
check for suction.
Turn cleaner OFF and remove any block-
ages.
4-1
4. Before attaching nozzle to wands, check
nozzle connector (A).
Look into nozzle connector and remove
any blockages.
HOOVER and are registered trade-
marks
THE HOOVER COMPANY, NORTH
4-2
CANTON, OHIO 44720
4-98 S1420, S1337/39
Litho USA
A