Troy-Bilt 020213 Instrucciones De Uso página 10

Operation
HOWTO USEYOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at I =888=61 I =6708.
Pressure Washer Location
Pressure Washer Clearance
[ A wA..i.G 1
" Keep at least 5 ft. (I 52 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 8). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
WARNING
Operate pressure washer ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.
Typical Pressure
Washer Shown
Exhaust Port
How to StartYour Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
I. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.3 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump.
5. Turn ON water, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
CAUTION
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Attach nozzle extension to spray gun (Figure 9).
Tighten by hand.
7. Choose desired
spray tip, pull back nozzle extension
collar, insert nozzle and release collar.Tug on spray tip
to make sure it is securely in place (Figure 10). See
"How to Use Quick Connect SprayTips'.
: - 0 " . • _ . D o ® - - ,,
O