Troy-Bilt 020213 Instrucciones De Uso página 14

Section 4: Operation
Pressure Washer Rinsing
For Rinsing:
I. Engage trigger lock on spray gun.
2. Remove black detergent spray tip from nozzle
extension.
3. Select and install desired high pressure spray tip
following instructions "How to Use Quick Connect
SprayTips".
4. Keep spray gun a safe distance from the area you plan
to spray.
WARNING
Keep spray nozzle between 8 to 24 inchesaway from cleaning
surface.
Operate this unit on a stable surface.
Be extremely carefulif you must use the pressure washer from
a ladder,scaffoldingor any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
5. Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue rinsing.
6. Start at top of area to be rinsed, worldng down with
same overlapping strokes as you used for cleaning.
Cleanin ent Siphoning Tube
If you used the detergent siphoning cube,you must flush it
with clean water before stopping the engine.
I. Place detergent siphoning tube/filter in a bucket full of
clean water.
2. Engage trigger loci< on spray gun.
3. Attach black detergent spray tip.
4. Flush for I-2 minutes.
5. Shut off engine.
6. ALWAYS point gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engages to cool the pump by
discharging the warm water onto the ground.
4@