Troy-Bilt 020213 Instrucciones De Uso página 11

Section 4: Operation
8. Engage trigger lock on spray gun trigger (Figure II).
Loci<
9. When starting engine,position yourself as recommended
in Figure 12 and start engine according to instructions
given in engine operator's manual.Alsosee operating
instructions tag located on the pressure washer.
WARNING
ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release pressure and avoid kickback each time,
before starting engine.
When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
After each starting attempt, where engine fails to run, always
point gun in safe direction and squeeze spray gun trigger to
release high pressure.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
NOTE: Always keep the throttle lever in the "Fast"
)osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
Keep at least S ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arresten maintained in
effective working orden complying to USDA Forest service
standard 5 I00- I C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Ocher states may have similar laws.
How to StopYour Pressure Washer
I. Let engine idle for two minutes.
2. Turn engine off according to instructions given in
engine operator's
manual.
3. ALWAYS point gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT:
Spray
gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction and squeeze spray gun
trigge_, to release high pressure, every time you stop engine.
Engage trigger lock when not in use.
4. Engage trigger loci< on spray gun when not in use.
O