Replacing The Lithium Clock Battery - Brother QL-650TD Guía De Configuración Y Uso

7
Once set in the correct position, tighten the
screw which holds the cutting blade unit in
place.
8
Set the DK Roll and close the DK Roll cover.
For details, refer to

Replacing the lithium clock battery

A lithium battery is supplied in order to maintain the settings for the internal clock when
the printer unit is not plugged-in to a normal power supply. If the clock settings need to be
reset every time the printer unit is unplugged from its normal power source, then the
battery must be replaced.
For the lithium battery for replacement, purchase CR2032 (recommended manufacturer:
Hitachi Maxell, Ltd., FDK Corporation, Matsushita Electric Industrial Co.,Ltd., Sony
Corporation, Toshiba Corporation and VARTA Microbattery Inc.).
• Use only the authorized battery for the printer.
•
Dispose in accordance with all applicable federal,
state, and local regulations.
•
When storing or discarding the battery, wrap it with
adhesive cellophane tape etc. to prevent it from short-
circuiting.
•
It is recommended to replace the battery every two
years.
1
Turn OFF the power of this printer and pull the power cord out of the
outlet.
2
Open the DK Roll cover and pull up the roll
release lever to the up position and remove
the DK Roll.
"Setting the DK Roll" in page 23.
Example of grounding of battery
Adhesive cellophane tape etc.
Battery
57
STEP
1
STEP
2
STEP
3
STEP
4