Display Functions - Glass 1989 NUBEA Serie Manual De Uso

EN
1. AIRPOOL ON/OFF light/button
2. WHIRLPOOL ON/OFF light/button
3.CHROMOTHERAPY ON/OFF light/button
4. ON/OFF light/button
- Fill the bathtub up to the highest jets level
that allows the system functioning.
- The AIRPOOL and WHIRLPOOL
systems duration is pre-set for 30
minutes and it can not be changed.
TASTO ON/OFF
By pressing the button (4) you can turn the
keypad on and off.
WHIRLPOOL FUNCTION
To start the whirlpool function, push the
button (2). The "WHIRLPOOL system
functioning" RED led will light up. To stop
the WHIRLPOOL function before the
end of the set time, push again the same
button. Hydromassage intensity is fixed.
If you turn off the "red light" before the end
of the set time, indicates water missing;

DISPLAY FUNCTIONS

fill further the bathtub over the level of
the jets.
AIRPOOL FUNCTION
To start the AIRPOOL function, push
the button (1). The "AIRPOOL system
functioning" RED led will light up.
If you turn off the "red light" before the end
of the set time, indicates water missing;
fill further the bathtub over the level of the
jets [to start the AIRPOOL function, push
the button (1)].
If there is no water, the airpool does not
work.
The airpool system starts the cycle at the
minimum intensity. The airpool intensity
can be adjusted using button (1) (intensity
minimum→medium→maximum→OFF
airpool).
WARNING: the Blowing After works
only when the bathtub is empty. Do
not use the bathtub during the cycle.
Drain the bathtub completely at the end
of the cycle.
6