All the whirlpool bath components require frequent servicing. Follow the instructions
below with the greatest attention to avoid damaging the gloss of the acrylic and metal
parts.
EN
• Any installed safety provisions or safety equipment may not be modified or removed.
• While the whirlpool is operating, avoid using foaming products, vegetable preparations
and bath salts that are not completely soluble (potentially abrasive).
• Install a water softening system to eliminate scale.
• If the water is slow to drain away, check that in the drain outlet is clean.
■ TAPS AND FITTINGS - CERAMICS - NOZZLES - PROFILES
– ALUMINIUM PARTS - STEEL – PAINTED OR CHROME-
PLATED PARTS
Use a soft sponge dampened with water and non-abrasive neutral liquid detergents
for cleaning.
After cleaning, rinse thoroughly with plenty of water to remove all traces of
detergent and dry with a soft cloth.
a
:
void
– cleaning materials which contain hydrochloric acid, formic acid, bleach or acetic acid,
as they can cause considerable damage.
– synthetic fibre cloths, scouring pads, metal pads, abrasive detergents, alcohol, acids
for domestic use, acetone or other solvents which damage the surface.
–the build-up of limescale by cleaning regularly.
IMPORTANT:
Residues of toiletries such as liquid soaps, shampoos and shower gels, hair dyes,
perfumes, aftershave and nail varnish can also cause damage.
Rinse thoroughly with plenty of water to remove all traces of detergent.
■ ACRYLIC SURFACES
Use soft cloths and non-abrasive neutral liquid detergents to clean the product.
After cleaning rinse thoroughly with clean water to remove any cleaner residue.
To ensure that the glossy surface is maintained over the years, do not use water above
60° C.
a
:
void
– synthetic fibre cloths, scouring pads, metal pads, abrasive detergents, alcohol, acids
for domestic use, acetone or other solvents which damage the surface.
– essential oils or bath salts.
In order to remove small scratches or burns on the surface and re-establish their gloss,
ROUTINE AND SPECIAL MAINTENANCE
WARNING
WARNING
8