Volume Control - Glass 1989 NUBEA Serie Manual De Uso

To start the "blowing after", push the button
(1). The "airpool system functioning" led
starts flashing. To confirm the start-up of
the function, push again the button at the
third flash.
CHROMOTHERAPY
To start the chromotherapy function, just
press the button (3).
The first time the button is pressed the
WHITE LIGHT mode switched on.
Pushing again the button (3) lamp change
colour until to switched off.
BLUETOOTH
Bluetooth allows several devices enabled
with the function to communicate with
each other within a radius of some tens
of metres.
Before you can use this function, the
transmitter (MP3 players, mobile phones,
PCs and other players with Bluetooth
2.1) must be connected to the Bluetooth
receiver in the product.
PAIRING OF DEVICES
To search for other devices, do a scan with
the transmitter (see transmitter guide).
The presence of a Bluetooth receiver will
be displayed with the word "PROW-BT".
Select the "PROW-BT" device and proceed
with the pairing.
After the pairing the "PROW-BT" device
will be saved in the "paired devices" list.
Now you can start an audio track through
the transmitter PLAYER.
NOTE: the Bluetooth "PROW-BT" may
not be compatible with all the functions
enabled on your Bluetooth transmitter,
e.g. functions of track progress, volume
control, etc. For more details, consult the
user's guide of your device.

VOLUME CONTROL

The volume is controlled from the
transmitter (MP3 readers, mobile phones,
PCs...) if enabled with this function.
SANITIZING FUNCTION
Fill the bathtub up in order to start the
SANITIZING FUNCTION system.
The function is activated only with keypad
off, button (4) OFF.
To start the SANITIZATION function, push
the button (2) at least for 3 seconds.
The "SANITIZATION system functioning"
led starts flashing. To confirm the start-up
of the function, push again the button at
the third flash and the led turns into RED.
If the disinfectant or the water level are
missing, the sanitization function does not
work. This status is indicated by "flashing
red led".
• Lift the cap of the dispenser on the
edge of the bathtub and fill it with the
disinfectant.
• The water level is missing, fill further the
bathtub, over the level of the jets.
No other function is available during this
cycle.
®
At the end of the cycle, the led keeps
being alight until the bathtub is completely
emptied. Then, we suggest doing a
"blowing after" cycle of the airpool circuit,
by pushing the airpool button (1).
WARNING: do not use the bathtub
during the cycle. drain the bathtub
completely at the end of the sanitization
cycle.
7
EN