Condensate Drain; Shortening Of Vent Extensions - Ubbink Rolux Instrucciones De Instalación

Condensate drain
B
A
male
appliance top
Annually inspect the collector and trap for obstructions and fluid content in the trap.
Drain and dispose of condensate per local codes.
If the appliance has an integrated condensate collector, remove the drain cap and install a
condensate trap per the installation instructions.
If the appliance does not have an integrated condensate collector, then install a
condensate collector and trap as close as possible to the appliance.
Shortening of vent extensions
0.4 inch (10 mm)
0.4 inch (10 mm)
The aluminum inside pipe should always extend 0.4" (10 mm) beyond the white outside
pipe on the male end of the vent extension.
Always cut the male end of the vent pipe extension. Do not attempt to cut the female end.
1.25"
1.25"
X + 2.5" (X + 65 mm)
X + 2.5" (X + 65 mm)
0.4" (10 mm)
WARNING
Improper installation of vent system and components, or failure to follow
all installation instructions, can result in property damage or serious injury.

B
D
D
female
C
appliance top
C
y
y
X 1.25"
X 1.25"
0.4" (10 mm)
Condensate can damage the water
heater, please read carefully page 4
in this installation manual.
To prevent condensate from draining
back to the appliance, a condensate
collector (B) and trap (C) should be
used. The trap must maintain 3" of
fluid and the drain tube must pitch
down from the appliance.
white
(outer)
white aluminum
(outer) (inner)
Pipes overlap by 1.25" (37 mm). Therefore
when cutting to size, add 2 x 1.25 = 2.5"
(65 mm) to the extension pipe length (X)
needed for installation.
Deburr the sharp edges, other wise the
gaskets might get damaged, which can
result in the system no longer being air
tight.
aluminum
(inner)