Final Installation Of The Vent System - Ubbink Rolux Instrucciones De Instalación

3
Final installation of the vent system
Case A:
Installation with Male Appliance Top
After cutting the appropriate length, slide the Horizontal Termination through
the hole in the wall. Position the first rubber wall plate around the male end
of the termination.
Case A: Slide the male end of the termination in the Horizontal Discharge Adapter.
Case B: Slide the male end of the termination into the 90° Vent Pipe Elbow.
Fill the gaps between the wall and the vent pipe penetration with a weather proof
Sealant. Finally, position the second rubber wall plate around the vent pipe, between
The end of the termination and the exterior wall.
NOTE
Condensate can damage the water heater, please read carefully page  in
this installation manual.

Case B:
Installation With Female Appliance Top
NOTE
First place innerwall plate to
slide terminal through