Inserting The Batteries - oneConcept 10029373 Manual Del Usuario

Display Console Set Up
The sensor array must be powered and updating before powering up the console, or the
console will time out searching for the sensors. Power the console last.
Make certain the weather station sensor array is at least 3m away from the console and
within 30m of the console. If the weather station is too close or two far away, it may not
receive a proper signal. If you have more than one Thermo-hygrometer transmitter, make
sure they are all powered up and transmitting on different channels.

Inserting the Batteries

Insert four AA (alkaline or lithium)) batteries in the back of the display console. The display
will beep once and all of the LCD segments will light up for a few seconds to verify all seg-
ments are operating properly. The console will cycle through a spectrum of colors.
NOTE: The character contrast is best from a slightly elevated viewing angle.
Replace the battery door, and fold out the desk stand and place the console in the upright
position.
35