oneConcept 10029373 Manual Del Usuario página 47

History Graph Mode
The historical graph on the display changed to display the measured parameters. In normal
mode, press the HISTORY/- key to toggle between:
• outdoor humidity graph (the HUMIOUT icon is displayed)
• outdoor temperature graph (the TEMPOUT icon is displayed)
• indoor humidity graph (the HUMI-IN icon is displayed)
• indoor temperature graph (the TEMP-IN icon is displayed)
• the wind speed graph (the WIND icon is displayed),
• the rainfall graph (the RAIN icon is displayed)
NOTE: The outdoor humidity and temperature graph will display history graph of current
channel.
Reset Min/Max record
NOTE: If you own more than one thermo-hygrometer sensor, the minimum and maximum
value of all channels will be cleaned in cleaning mode.
In normal mode press and hold the HISTORY/- key for 3 seconds, and the maximum values
will begin flashing and the MAX CLR icon will be displayed. Press the SET key to clear the
maximum values of rainfall, wind speed, temperature and humidity. The maximum values
will now display the current values. In MAX CLR mode, the MAX zone will display the maxi-
mum value of rainfall.
Press the HISTORY/- key again (do not hold), and the minimum values will begin flashing
and the MIN CLR icon will be displayed. Press the SET key to clear the minimum values. The
minimum values will now display the current values.
Press the ALARM key to exit the min/max checking and cleaning mode, return to normal
display mode.
NOTE: The minimum and maximum value clean of rainfall will be the selected 1h, 24h, week
or month in cleaning mode.
Snooze Mode
If the alarm sounds, and you wish to silence the alarm, press the SNOOZE/LIGHT key, the
backlight will turn. The alarm icon will continue to flash and the alarm will silence for five
minute. Press any key (HISTORY/+ ,SET, ALARM,CHANNEL/+) to permanently exit the
Snooze mode.
47