oneConcept 10029373 Manual Del Usuario página 51

The following is a list of the individual alarm parameters that are set (in order):
• Alarm hour
• Alarm minute
• Indoor temperature high alarm
• Indoor temperature low alarm
• Indoor humidity high alarm
• Indoor humidity low alarm
• Outdoor 1 (channel 1) temperature high alarm
• Outdoor 1 (channel 1) temperature low alarm
• Outdoor 1 (channel 1) dew point high alarm
• Outdoor 1 (channel 1) dew point low alarm
• Outdoor 1 (channel 1) wind chill high alarm
• Outdoor 1 (channel 1) wind chill low alarm
• Outdoor 1 (channel 1) humidity high alarm
• Outdoor 1 (channel 1) humidity low alarm
• Wind speed high alarm
• Gust high alarm
• Rainfall (1h) high alarm
• Rainfall (24h) high alarm
To prevent repetitive alarming of temperature, there is a 0.5 °C tolerance band. For examp-
le, if you set the high alarm to 26.7 °C and silence the alarm, the alarm icon will continue
to flash until the temperature falls below 26.2 °C, at which point, the alarm will reset and
must increase above 26.7 °C to activate again.
To prevent repetitive alarming of humidity, there is a 4% tolerance band. For example, if
you set the high alarm to 60% and silence the alarm, the alarm icon will continue to flash
until the humidity falls below 56%, at which point, the alarm will reset and must increase
above 60% to activate again.
Alarm and Command Key Beeper ON/OFF Mode
The beeper can be silenced for both alarms and key strokes. In normal mode, press and
hold the ALARM key for five seconds to toggle the beeper on or off (depending on the cur-
rent setting).
The BUZZON (beeper on) or BUZZOFF (beeper off) icon will appear in the time area for
three seconds. Press and hold the ALARM button again for five seconds to toggle the BUZ-
ZON or BUZZOFF command.
51