oneConcept 10029373 Manual Del Usuario página 36

The unit will instantly display indoor temperature, humidity, date and time. The wind speed,
wind direction, rain, and outdoor temperature and humidity will update on the display within
a few minutes. Do not Press any menu buttons until the outside transmitter report in,
otherwise the outdoor sensor search mode will be terminated. When the outdoor transmit-
ter data has been received, the console will automatically switch to the normal mode from
which all further settings can be performed.
While in the search mode, the remote search icon
have more than one thermo-hygrometer sensor (up to eight thermo-hygrometer sensors
are supported), the display will automatically toggle between sensors until all sensors have
reported in. If it does not update, please reference the troubleshooting guide
NOTE: If the power adapter is plugged in, AC ON will display in the time area for three
seconds when powered up. Conversely, if the power adapter is not plugged in, AC OFF will
be displayed.
Sensor Operation Verification
The following steps verify proper operation of the sensors prior to installing the sensor
array.
• Verify proper operation of the rain gauge. Tip the sensor array back and forth several
times. You should hear a "clicking"sound within the rain gauge. Verify the rain reading
on the display console is not reading 0.00. Each "click"represents 0.01 inches of rainfall.
• Verify proper operating of the wind speed. Rotate the wind cups manually or with a con-
stant speed fan. Verify the wind speed is not reading 0.0.
• Verify proper operation of the indoor and outdoor temperature. Verify the indoor and out-
door temperature match closely with the console and sensor array in the same location
(about 3m apart). The sensors should be within 2°C (4°F) (the accuracy is ±1°C/2°F).
Allow about 30 minutes for both sensors to stabilize.
• Verify proper operation of the indoor and outdoor humidity. Verify the indoor and outdoor
humidity match closely with the console and sensor array in the same location (about
10'apart). The sensors should be within 10% (the accuracy is ± 5%). Allow about 30
minutes for both sensors to stabilize
36
will be constantly displayed. If you