oneConcept 10029373 Manual Del Usuario página 54

Problem
Wireless remote not
reporting in to console or
there are dashes (--.-) on
the display console.
Temperature sensor reads
too high in the day time.
Indoor and Outdoor
Temperature do not agree
Indoor and Outdoor
Humidity do not agree
Display console contrast is
weak
Outdoor color does not
change as expected.
Rain gauge reports rain
when it is not raining
Wind speed appears low
54
Solution
Move the display console around electrical noise generating
devices, such as computers, TVs and other wireless trans-
mitters or receivers. Move the remote sensor to a higher
location. Move the remote sensor to a closer location.
Make sure the thermo-hygrometer is mounted in a shaded
area. The pre preferred location is a north facing wall be-
cause it is in the shade most of the day.
Allow up to one hour for the sensors to stabilize due to si-
gnal filtering. The indoor and outdoor temperature sensors
should agree within 2 °C (the sensor accuracy is ± 1 °C).
Use the calibration feature to match the indoor and outdoor
temperature to a known source.
Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor humidity sensors
should agree within 10 % (the sensor accuracy is ± 5 %).
Use the calibration feature to match the indoor and outdoor
humidity to a known source.
Replace console batteries with a fresh set of batteries.
Make sure the outdoor sensor is assigned to Channel 1.
An unstable mounting solution (sway in the mounting pole)
may result in the tipping bucket incorrectly incrementing
rainfall. Make sure you have a stable mounting solution.
Move the rain gauge from the pole mount to a flat, stable
mount (fixed, flat structure).
Average wind speed may have the appearance of low wind.
Try switching the display to wind gust.