Yakima Universal MightyMount Manual Del Usuario página 5

WATER* and UPRIGHT
BIKES**
long
cARRIAge bolt
(accessory here)
sPAceR
nut
WRencH
cobra and
Kingcobra
(Cobra knob)
(Cobra plate)
ADAPteR
use cobRA
cARRIAge bolt
WRencH WRencH
1033297H - 5/24
*KayaK sTacKers (single-post style) will not
**HUllraisers will not work with this product.
**anKleBiTers will not work with this product.
**cOBra carriers see BelOw.
REMOVE THE UPPER PAD BEFORE CONTINUING.
1. Insert the long carriage bolt through the accessory and
into the spacer (your accessory may look different).
2. Secure the spacer and accessory to the backbone using
the nut. Tighten with wrench.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and wheel.
5. Read warnings on final page!
SPACER POSITION:
if your factory bars are angled, and the spacer is not
flat against the accessory, loosen the carriage bolt
and rotate the spacer on the MightyMount.
You will need to remove the pad; be sure to replace
it once the bolt is tightened.
REMOVE THE UPPER PAD BEFORE
CONTINUING.
1. Insert the carriage bolt from your Cobra
carrier, through the adapter and the
Cobra plate.
2. Secure the adapter and Cobra plate to
the backbone using the Cobra knob.
3. Reattach the pad.
4. Attach to crossbar, secure with bail and
wheel.
5. Read warnings on final page!
ADAPTER POSITION:
if your factory bars are angled, and the
adapter is not flat against the accessory,
loosen the carriage bolt and rotate the
adapter on the MightyMount.
You will need to remove the pad; be sure
to replace it once the bolt is tightened.
work with this product.
MORE BIKES: continued next page...
BiKe wHeel Tray:
Use the short carriage
bolt from this kit.
cOBra wHeel Tray:
Use the long carriage
bolt from this kit.