Yakima Universal MightyMount Manual Del Usuario página 7

BASKeT CASe (cargo):
long
cARRIAge bolt
sPAceR
nut
WRencH
SPACER POSITIONING:
if your factory bars are angled, and the
spacer is not flat against the accessory,
loosen the carriage bolt and rotate the
spacer on the MightyMount.
You will need to remove the pad, be sure
to replace it once the bolt is tightened.
1033297H - 7/24
bAsKet cAse
WIRe clIP
REMOVE THE UPPER PAD BEFORE
CONTINUING.
1. Insert the long carriage bolt
through the wire-clip and basket
loops, into the spacer and
backbone.
2. Secure the spacer and basket
to the backbone using the nut.
Tighten with wrench.
3. Reattach the pad.
4. Attach to crossbar, secure with
bail and wheel.
5. Read warnings on final page!
Be sure the bolts pass
through the wire loops on the
BOTTOM of the basket.
Basket will sit above bars as in option B
and C (BasketCase instructions).