Installation; Connection; Configuration Knx - hager TX460 Instrucciones De Uso

2. Installation

2.1 Connection

2
• Connect BCU to bus via connector
• Screw the mounting plate
flush-mounting box.
3
• Clip the front face on BCU.
Install the environment control and regulation 1.50m up from
floor level to make it visible.
2
1
78
1
.
2
and BCU onto the
3

2.2 Configuration KNX

The environment control and regulation can be configured by:
TX100: detailed description
can be found in User's
Instructions supplied with
Configurer Tebis.
! The link between the thermostat
and the output driver must be
carried out in mode + Info on
TX100.
ETS : application software TX460.
! First configure environment control and regulation via
TX100 or ETS software.
Then carry out front face configuration.
79