Installation Set-Up - hager TX460 Instrucciones De Uso

9.2 Installation set-up

This menu is used to select the type of
installation controlled
environment control and regulation in
order to finely set regulation features.
Installation type
This sub-menu is used to select the type of heating or cooling
equipment controlled and set regulation features.
• Select type of controlled equipment
(or equivalent type) using button
and
• Press button
to Installation screen.
To enter user regulation settings (expert mode):
• Select
button
• Press button
• Set up the 1
confirm and move to the next
parameter.
• Follow the same steps for the 3 other parameters, then press
button to confirm and return to menu Installation.
102
by the
.
to confirm and return
User Settings line using
and .
to confirm.
st parameter using button
and Press button
Probe calibration
This sub-menu allows correcting the room temperature as
measured by your thermostat (within +/- 2°C limits).
Min./Max. Set point
This sub-menu allows defining a minimum and maximum
temperature set-point value for heating or cooling.
When all Installation parameters are set up, press button
to return to the Installation set-up screen.
to
103
• Correct the room temperature value
as measured by your thermostat using
button and Press button
to confirm and return to menu
Installation.
• Set the minimum set-point value
using button and .
• Press button to confirm and move
to the maximum set-point value.
• Set the maximum set-point value
using button and .
• Press button to confirm and to
return to the Configuration screen.
◀
C