Torch Neck Liner; Connecting The Cable Assembly; Connecting The Coolant - Binzel ABIMIG WT Instructivo De Servicio

®
ABIMIG WT

4.2.3 Torch neck liner

Fig. 2 Torch neck liner

4.3 Connecting the cable assembly

4.4 Connecting the coolant

1 Unscrew torch neck from handle.
2 Introduce torch neck liner with the stripped side into the torch neck until the
stop at the contact tip.
3 Cut off torch neck liner free of burr such that it protrudes 30 - 31mm.
4 Screw torch neck into the torch mount of the handle.
For welding tasks which absolutely require a continuous wire guide, please
consult the supplier's or manufacturer's Service Department.
1 Join the central connector and the central socket at the wire feeder.
2 Use the connection nut to secure both of these.
3 Attach the cooling water supply and return connectors
4 Attach the shielding gas and control lead connectors in the case of other
machine connections.
WARNING
Risk of burns
The cable assembly overheats if the coolant level is too low.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
4 Putting into operation
30-31mm
EN - 9