Bosch JS470E Instrucciones De Funcionamiento Y Seguridad página 18

Service
thorized personnel
misplacing of
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
Tool Lubrication
Your Bosch tool has been properly
lubricated and is ready for use. It is
recommended that tools with gears be
regreased with a special gear lubricant
at every brush change.
Carbon Brushes
The brushes and commutator in your
tool have been engineered for many
hours of dependable service. To
maintain peak efficiency of the motor,
we recommend every two to six months
the brush es be examined. Only genuine
Bosch replace ment brushes specially
designed for your tool should be used.
To avoid accidents, always disconnect the battery pack from tool
before servicing or cleaning.
Preventive maintenance
performed by
may result
internal wires
Maintenance
Bearings
Bearings which become noisy (due to
un au - heavy load or very abrasive material
in cutting) should be replaced at once to
and avoid overheating and motor failure.
Cleaning
damage plastic parts. Some of these
are: gasoline, car bon tetrachloride,
chlorinated cleaning solvents, ammonia
and household detergents that contain
ammonia.
Ventilation openings and switch levers
must be kept clean and free of foreign
matter. Do not attempt to clean by
inserting pointed objects through
opening.
CLEANING BLADE HOLDER
Clean the saw blade holder regularly.
For this, remove the saw blade from the
tool and lightly tap footplate on a level
surface.
Regularly spray penetrating oil onto the
saw blade holder.
Check the guide roller regularly. If worn,
it must be replaced through an
authorized Bosch Factory Service
Center
Lubricate the guide roller occasionally
with a drop of oil.
-18-
Certain cleaning
agents and solvents