Connecting Power Cord; Machine Operation; Pre−Operation; Cleaning Carpets - Nobles SPEED EX Manual Del Operaripo

CONNECTING POWER CORD

1. Plug the supplied power cord into the machine and
attach the power cord to the strain relief clip as
shown (Figure 7).
FOR SAFETY: Do not operate machine unless
power cord is properly grounded. Only use the
manufacturer−supplied power cord which is
designed exclusively for this machine. Do not use
additional extension cords.
2. Plug the power cord into a properly grounded wall
outlet (Figure 8).
FIG. 7
WARNING: Electrical Hazard, Do Not Operate
With Damaged Power Cord.
If the power cord is damaged or broken, it must be
replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a
hazard.
3. Wrap the power cord around the handle and cord
hook when storing machine. To remove power
cord, turn the cord hook upward (Figure 9).
Nobles Speed Ex (03−08)
Grounded
3 Hole Outlet
Grounded Pin
FIG. 8
FIG. 9

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE−OPERATION
1. Inspect power cord for damage.
2. Vacuum the carpet and remove debris from area.
3. Using a pump−up sprayer, spray the carpet with an
approved pre-treatment detergent (Figure 10).
Contact your dealer for recommended cleaning
detergents.
FIG. 10
WARNING: Fire Or Explosion Hazard. Do Not
Use Flammable Materials. Only Use Commercially
Available Floor Cleaners intended for machine
application.

CLEANING CARPETS

WARNING: Fire or Explosion Hazard, Do Not
Use or Pick Up Flammable Materials.
1. Pull the handle adjustment lever and adjust the
handle to a comfortable operating height (Figure
11). Release the lever to lock the position.
FIG. 11
OPERATION
EN
7