General Toolsmart TS04 Manual Del Usuario página 6

• •WARNING Do not apply more than the rated voltage, as marked on the
meter, between the
Also do not input more than the rated current, as marked on the meter,
through the A jack.
• •WARNING Do not measure voltages above 600V in Category III
installations.
• •WARNING Do not attempt to measure voltage with the rotary function
switch in any position other than . Never attempt to measure current with
the rotary function switch in any position other than
• Use caution when working with voltages above 42VAC
voltages pose a shock hazard.
• •WARNING Do not operate the meter around explosive gas, vapor, or dust.
• •WARNING When using the probes, keep your fingers behind the finger
guards. Do not touch the metal probes of the test leads when making a
measurement.
• When making connections, connect the black (–) test lead before connecting
the red (+) test lead; when disconnecting, disconnect the red (+) test lead
before disconnecting the black (–) test lead.
• Disconnect circuit power and discharge all high-voltage capacitors before
measuring/testing resistance, continuity or diodes.
• For all DC functions in both auto and manual ranging mode, to avoid the risk
of shock due to possible improper reading verify the presence of any AC
voltages by first using the AC function. Then select a DC voltage range as
wide or wider than the AC range.
• Before measuring current, turn off power to the circuit before connecting the
meter.
• Do not operate the meter with the case (or part of the case) removed.
• Replace the battery as soon as the low battery indicator
Operated with a weak battery, the meter might produce false readings that
could lead to electric shock and personal injury.
• Remove the test leads from the meter before opening the meter case or
battery compartment.
6
TEMP
and COM jacks or between any jack and ground.
mAµAVΩ
, or .
µA mA
A
, or 60VDC. These
RMS
appears.