Publicidad
Enlaces rápidos
FRONT UNDER SPOILER
PART.No
①
REASON OF REVISION
P8 added.(Marking method when pre-arranged mark cannot seen.)
01
E2410FL000
×１
⑤
⑥
×４
×２
pattern
⑨
9.5mm
7mm
3mm
DESCRIPTION
FUJI HEAVY INDUSTRIES, LTD.
(1)
Applicable : IMPREZA (17MY~ )
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
②
③
×１４
⑦
×２
＋
⊿01
④
×１４
×１４
⑧
×２
×１
8mm
DATE
22 Nov.2016
161122
Publicidad
Manuales relacionados para STI E2410FL000
Resumen de contenidos para STI E2410FL000
- Página 1 ⊿01 Applicable : IMPREZA (17MY~ ) FRONT UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2410FL000 ① ② ③ ④ ×１ ×１４ ×１４ ×１４ ⑧ ⑤ ⑥ ⑦ ×２ ×４ ×２ ×２ pattern ⑨ ×１...
- Página 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
- Página 3 NOTE: This instruction shows only LH side. Please repeat the steps on RH side. detergent pre-arranged mark （size５ｍｍ） Caution ※2 ※2 ※2 When this pre-arranged ※2 mark can not be seen. :Go to P8 marking point ※2 (Marking by pattern paper) ※2 ※1...
- Página 4 9.5mm...
- Página 5 Front Bumper ③ Front Bumper ⑦ Front Bumper ⑦ Caution ① Do not remove this clamping band. Front Bumper Mud Guard Front Bumper ⑤ ⑤ Please use the new clips included in this kit. ① ⑤...
- Página 6 ⑥ ④ ② Bumper × ○ Front Under Spoiler Be careful not to rolled up the edge rubber between the bumper face and the Front Under Spoiler.
- Página 7 ⑧ step of the spoiler ④ Ｐａｓｔｅ cushion ② to under the bumper surface. 1.0±0.5N･m （0.8±0.3 lb-ft） Attach cushion to the step of the spoiler. ⑥ 2.0±0.5N･m （1.5±0.3 lb-ft）...
- Página 8 Caution : Marking method when pre-arranged mark cannot be seen. (1) Print this paper and check if the scale is correct. (2) Cut out the pattern paper. (3) Paste the pattern paper according to the bumper shape. (4) Mark the hole center of the pattern. note The figure shows the left, the right is symmetrical.