Página 1
⊿01 Applicable : WRX, WRX-STI (2015MY~) REAR SIDE UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E5610VA000 ① ② ③ ④ ⑤ ×4 ×4 ×2 ×2 ×1 pattern set ⑥ pattern pattern ARH ALH ×1...
Página 2
<CAUTION> (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 2.5 cm (1 inches) respectively.
Página 3
NOTE: Do not wash the vehicle for 24 hours following installation of this product. If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products. The recommended adhesive surface temperature range is 77 F - 104 F(25℃...
Página 4
Attach pattern A sheet to the bumper edge, and then mark to the intersection on the pattern sheet. pattern ⑥ A 3mm→6mm Bumper ② ② ② clip...
Página 5
Peel 30mm of the tape liner, and seal with tape on the outside of the Rear side under spoiler. ③ Tighten the screws temporarily. ⑤ Please use new clip included in this kit. ④...
Página 6
2 Butting point 3 SEIKQ 4.5 kg 10 sec (10 lbs) Butt the edge of the Rear side under spoiler 1 onto the bumper undersurface. ② 1.5±0.5N・m (1.1±0.3lb-ft) Tighten the screws completely. 120N・m(88.5lb-ft) Re-install the rear tire to the vehicle.