Publicidad
Enlaces rápidos
SIDE UNDER SPOILER
PART.No
①
pattern
⑩
E2610FL010
Ft
×１
10mm
9.5mm
6mm
FUJI HEAVY INDUSTRIES, LTD.
(1)
Applicable : IMPREZA (17MY~ )
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
②
③
×２０
×２０
⑥
⑦
×２
×４
＋
3mm
⊿00
④
⑤
×２０
×２
⑧
⑨
×４
×２
8mm
140219
Publicidad
Manuales relacionados para STI E2610FL010
Resumen de contenidos para STI E2610FL010
- Página 1 ⊿00 Applicable : IMPREZA (17MY~ ) SIDE UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2610FL010 ① ② ③ ④ ⑤ ×２０ ×２０ ×２０ ×２ ×１ ⑥ ⑦ ⑧ ⑨ ×２ ×４ ×４ ×２ pattern ⑩...
- Página 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
- Página 3 NOTE: Do not wash the vehicle for 24 hours following installation of this product. If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products. The recommended adhesive surface temperature range is 77 F - 104 F(25℃...
- Página 4 Marking position Shape alignment Shape alignment Side sill spoiler ⑩Pattern Ａ ⑩Pattern Ｂ Pattern Ｂ Pattern Ａ Side sill spoiler Marking position Side sill spoiler Attach pattern sheets ( ) to shown face of OE side sill spoiler, and then mark to the intersection on the pattern sheet. １...
- Página 5 Side sill spoiler Insert ③ into the 10×φ9.5mm holes. Side sill spoiler Neutral detergent or white gasoline , etc. Detergent Waste cloth Degreasing cleaning section Masking tape Masking tape Exfoliate paper Each release paper of double-sided tape of the side under spoiler inside peel off about 2 to 5 cm from the terminal , the front side with masking tape bent outward ( tape of the last end inside) and paste it in .
- Página 6 Side sill spoiler a part a part details ①Side under spoiler ⑤Clip （Φ１０） ⑤Clip （Φ１０） ①Side under spoiler Side sill spoiler ④ ② Side sill spoiler Side sill spoiler ☆ ① Side under spoiler With no gap ☆ ２ ３ １...
- Página 7 ①Side under spoiler Side sill spoiler ｂ ｂ ｂ ｂ ｂ ｂ １ ２ ３ ４ ５ ６ ７ ８ ９ ②Bolt Ａ (1.0±0.5N･m) Tighten the screws completely. ▲The outside of the vehicle ①Side under spoiler Conform to the side sill spoiler shape Side sill spoiler b part detailed view...
- Página 8 Vehicle side panel Vehicle side panel ｃ ｃ ⑨Cushion ⑨Cushion ｃ‐ｃSectional view d section details ⑧Color ⑥Bracket ｄ ⑦Bolt Ｂ ｄ ⑨Cushion ⑥Bracket ⑧Color ⑦Bolt Ｂ ｄ‐ｄ Sectional view ・Re-install the OE side sill spoiler. ・Re-install the rear tire. ※Please refer to the Subaru service manual for details .