Publicidad
Enlaces rápidos
SIDE UNDER SPOILER
PART.No
①
pattern set
⑨
pattern
pattern
ＡＲＨ
Δ
E2610CA010
×１
pattern
ＡＬＨ
Ｂ
×１
8mm
6mm
3mm
Reason of revision
FUJI HEAVY INDUSTRIES, LTD.
Fr
②
③
×６
×２
⑥
⑦
×４
×４
＋
(1)
Applicable :BRZ (13MY~)
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
④
⑤
×６
×２
⑧
×４
8mm
Date
160215
⊿00
Publicidad
Manuales relacionados para STI E2610CA010
Resumen de contenidos para STI E2610CA010
- Página 1 ⊿00 Applicable :BRZ (13MY~) SIDE UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2610CA010 ① ② ③ ④ ⑤ ×１ ×６ ×２ ×６ ×２ ⑥ ⑦ ⑧ pattern set ⑨ pattern pattern pattern ＡＲＨ ＡＬＨ...
- Página 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
- Página 3 NOTE: Do not wash the vehicle for 24 hours following installation of this product. If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products. The recommended adhesive surface temperature range is 77 F - 104 F(25℃...
- Página 4 Mersure 1.9in (48mm) above the #7 clipand apply a piece of masking on the vehicle as shown in theimage. ⑦ 1.9in(48mm) 0.79in(20mm) Confirm that the screw hole center of the ⑦clip is in the vehicle center direction from a Mad Gurad sidewall. Mud Guard 2.0in(50mm) vehicle center direction...
- Página 5 Clip Grommet detergent ② ① Attach② to the 3 brackets on the side under spoiler.
- Página 6 Peel 30mm of the tape liner, and seal with tape on the outside of the Side under spoiler. ⑧ ⑤ ⑥ Please use new clip included in this kit. Tighten the screws temporarily. ③ ④ Please use new clip included in this kit.
- Página 7 Vehicle Side Panel Masking Tape marking Top edge of side under spoiler Set the side under spoiler on the side panel along three pieces of masking tape.The top edge ①Side under Spoiler of the side under spoiler should meet with the bottom of the masking tape.