notice:
1. This is an ISOFIX CHILD RESTRAINT SYSTEM. It is approved to Regulation No. 44, 04
series of amendments for general use in vehicles fitted with ISOFIX anchorages
systems.
2. It will fit vehicles with positions approved as ISOFIX positions (as detailed in the vehicle
handbook), depending on the category of the child seat and of the fixture.
We recommend customer to check compatibility of the child restraint with the
intended vehicle prior to fitting. The compatibility list can be found on the back of the
instruction manual or our website:
http://www.cosatto.com/products/car-seats/hold-group-0-infant-car-seat/fitting
3. When fitted with the hold car seat, the mass group and the ISOFIX size class for
which this device is intended is: Group 0+ (0 – 13kg), Class E.
4. Never use this child car seat on passenger seat fitted with active airbag.
5. lf in doubt, consult either the child restraint manufacturer or retailer.
care
Your child car seat base has been designed to meet safety standards and with correct use
and maintenance will give many years of trouble free performance.
Storing a damp child car seat base will encourage mildew to form.
After exposure to damp conditions, dry off with a soft cloth and allow to dry thoroughly
before storing.
Store your child car seat base in a dry, safe place.
Leaving the child car seat in sunlight for prolonged periods may cause fabrics to fade.
maintenance
Inspect the child car seat base regularly for signs of damage- stop using the product if
any of the component have become damaged.
When fitted to vehicle seat, check the fitting child car seat base regularly to ensure the
fitting is secured and the child car seat harness are not obstructed or twisted.
DO NOT take apart, or attempt to take apart the car seat base when cleaning. It is
unnecessary and dangerous to do so.
cleaning
Plastic and metal parts may be sponged clean with warm water and a mild detergent.
Never clean with abrasive, ammonia based, bleach based or spirit type cleaners.