Connecting The Drain Hose; Electrical Connections; The First Wash Cycle; Technical Data - Indesit IWC 81251 Manual De Instrucciones

Connecting the drain hose

! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held respon-
sible in the event that these regulations are not
respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle 2.

Technical data

Model IWC 81251
width 59.5 cm
Dimensions height 85 cm
depth 57.2 cm
Capacity from 1 to 8 kg
Electrical
please refer to the technical
connec- data plate fixed to the machi-
ne
tions
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05 MPa
nection
(0.5 bar)
drum capacity 54 litres
Spin speed up to 1200 rotations per
minute
Test wash
cycles in
Programme 2: Cotton stan-
accordance
dard 60°;
with re-
gulations
Programme 3: Cotton stan-
1061/2010
dard 40°.
and
1015/2010.
This appliance conforms to
the following EC Directives:
- 2004/108/CE (Electromagne-
tic Compatibility)
- 2012/19/EU - WEEE
- 2006/95/EC (Low Voltage)
GB
3