Field Of Application; Product Description; Particular Advantages; Technical Data - Trisk CureMate 2 Manual De Funcionamiento, Ensamble Y Piezas De Recambio

English
2.

Field of application

A mobile dryer is an essential aid for paint repair on
small and medium-sized areas.
It is used to accelerate the drying of putty, filler, base
and top coats.
This applies to both water-based and solvent-based
products. Its site of use is the preparation area and fin-
ishing area. Within the automotive industry and vehicle
maintenance sectors, it is used to dry small areas and
cure materials on vertical surface before polishing.
3.

Product description

The easily manoeuvrable CureMate 2 is equipped with
a compact cassette. The cassette is equipped with 3 IR
lamps with aluminium reflectors and a ventilator. The
design makes cassette adjustment simple. The IR lamps
and reflectors are protected against mechanical damage
with a mesh. The control unit enables flash off (5.0 %
power) and full bake (100 % power). The time can be
set individually for each mode (0-30 min).

3.1 Particular advantages

3.1.1 Higher quality
Using the mobile dryer when you dry putty also
improves the quality of the top coat. The high surface
temperature and curing from the inside outwards drive
all solvents and other reaction products from the coated
material.
3.1.2 Short drying times
Putty
Filler
Primer
Water-base
Base coat
Top coat
Clear varnish
3.1.3 Low energy consumption
Electrical energy is used efficiently through short-wave
technology and aluminium reflectors. Surfaces are sub-
jected to targeted irradiation. The air is not heated.
3.1.4 Good maneuverability
The units low weight makes the machines very competi-
tive, versatile and easy to use.

3.2 Technical data

Electrical diagram
See chapter 11
For machine reach and dimensions, see last page.
Mobile dryer users must adhere to these operating
instructions.
420942 rev2
4.
5.
3 -5. min.
5. - 10 min.
8 - 12 min.
4 - 6 min.
4 - 8 min.
8 - 12 min.
8 - 12 min.
Type 220V-240V
1 Ph/PE
Frequency 5.0 or 60 Hz
Rated power 3 emitters, full power 3000 W
Heating elements 3 quartz, tungsten filament, InfraRed emitters
Fuse* 16 A slow, type C
Drying surfaces 1,0 m x 0,9 m (width x height)
on black sheet metal
Weight
Noice level Less than 70 dB (A)
Max ambient temperature 40° Celsius
during operation
Max ambient temperature 70° Celsius
during storage and transportation
* The dryer must be supplied by recommended fuse.

Instruction to the owner

The owner of the mobile dryer must produce clear oper-
ating instructions, adapted to local site conditions, and
make these available to all users.
Mobile dryer users must adhere to these operating
instructions. This appliance is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety. Children should be super-
vised to ensure that they do not play with the appliance.
Dispose of spent items at the nearest environmental
protection facility for recycling.

Hazards

Fire and explosion
To reduce the risk of explosion, do not use in paint spray
booths or within 5. m/16 feet of paint spraying opera-
tions. Do not store, prepare or use solvent-containing
materials within a 5. m/16 feet radius of the mobile
dryer. Flammable materials should not be placed close to
a drying device in use. If you have a distance less than
60 cm/2 feet to the object the temperature might raise
quickly and the risk for fire increases. Never direct the
cassette towards highly combustible materials.
Electrical equipment
The mobile dryer is operated by highly dangerous electri-
cal voltage.
Accessing electrical equipment
Before accessing live parts, remove the main connec-
tor from the wall socket. Only professional electricians
may have direct access into the electrical equipment.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING!
Intensive heat radiation. Hands, face and other parts of
the body should be exposed as little as possible to the
heat radiation.
CureMate 2
(UK 13A) (NA 20 A)
23 kg
5