Campbell Hausfeld PW320200 Manual De Instrucciones página 11

Connect Spray Wand to Spray Gun
Thread the spray wand into the end of the spray gun.
Connect QC Nozzles to Spray Wand
Pull quick connect coupler back and insert nozzle. Release quick connect coupler and twist
nozzle to make sure it is secure in coupler.
Turn Water Faucet Completely On
Do not run the unit without water supply connected and turned on. Use Cold Water Only.
Release Air from System
Release all air from pump and high pressure hose by depressing trigger until a steady stream
of water is present. Approximately 30 seconds.
Move the Lever to the CHOKE
Pull the Recoil Starter Grip
Pull the recoil starter grip to start the engine.
Gradually move the Lever to the FAST
This Guide is not a substitute for reading the operator's manual. User must read
and understand operator's manual before using this product.
Position
Position after engine starts.
9
Figure 8
Figure 9
Figure 10
30 S
Figure 11
Figure 12
Figure 13
Figure 14